DMA Synchronous In Network Interface Card?

In general, this synchronisation happens via ring descriptor between NIC(Network Interface Card) and host CPU. You will get packet path details here. I have explained the ring-descriptors below.

Edit:

Let me explain with Intel’s ethernet Controller. If you look at section 3.2.3, where the RX descriptor format is given, it has status field which solves packet ownership problem. There are two major points to avoid contention and packet corruption as to who owns the packet (NIC driver or CPU).

DMA (from I/O device to Host memory): RX/TX Ring consists of ‘hardware descriptors’ and ‘buffers’ (carved from host memory). When we say DMA, controller transfer data, this happens from hardware FIFOs to this host memory.

1. Let us assume my ring buffers (of 512 bytes) are not big enough to hold the complete incoming packet(1500 or Jumbo packet), in that case the packet may span across multiple ring buffers and with EOP(End Of Packet) status field, indicates that the complete packet is now received (considering all the sanity checks/checksums are already done).
2. Second is who owns the packet now (driver or CPU for further consumption)? Now until the status flag DD (Descriptor Done) is set, it belongs to driver. Once set CPU can grab it for picking-and-poking.

This is specific to RX path. TX path is slightly different.

Consider it this way, there are multiple interrupts (IO, keyboard, mouse, etc) happening all the time in the system, but the time duration between two interrupts are so huge that CPU can do lot of other good stuff in between. And to further offload CPUs work DMA helps transferring data. So if an interrupt is raised and subroutine is called, all the subsequent interrupts can be masked as you are already inside that subroutine, but trust me these subroutine are very tiny they hardly consume any time until your next packet arrives. That means your packet arriving speed has to be higher than your processing speed.

Another Ex: for router/switches 99% time task is routing and switching hence subroutine and interrupt priorities are completely different, moreover all the time they are bombard with tons of packets and hence the subroutine in such cases will never come until there is another packet at bay. At least i have worked on such networking gears.